Timber framing built to the tolerance of the drawing.
Models, engineers, and pre-cuts the structural timber frame for custom homes and architectural projects — solved on the workstation, raised without guesswork.
Every NorthEdge frame begins as a full three-dimensional model, not a set of field assumptions. We carry that precision from the workstation to the job site, so what goes up matches what was drawn — on the first try.
Model
The full structural timber frame is built as a 3D model straight from the architect's drawing set, coordinated member by member before anything is ordered.
→Engineer
Connections, loads, and clashes are resolved on the workstation — where a mistake costs a keystroke, not a change order.
→Pre-Cut
Every timber and framing member is cut to spec on CNC equipment and labeled for its exact position in the frame, down to the piece.
→Assemble
Crews raise a frame that was already solved — faster, straighter, and closer to the drawing than field-cut framing allows.
What we frame
Capability built around one idea: solve it in the model, not on the wall. Every service below runs through the same digital fabrication process.
Pre-Cut Timber Framing
Complete structural packages cut off-site to exact spec, labeled, and delivered ready to stand — member by member.
CNC FabricatedHigh-End Residential Framing
Framing built to the standard a high-end custom home requires — square, true, and finished clean enough to build from.
Estate & CustomPrecision Timber & Structural Framing
Timber and structural systems executed to the tolerance the design calls for, not the tolerance field framing usually allows.
Joinery-GradeCustom Home Framing
Every custom home is a one-off structure. We treat the framing the same way — modeled and engineered for that house alone.
One-Off BuildsComplex Architectural Framing
Compound rooflines, cantilevers, curved walls, long-span glazing — the geometry most framers hand back to the architect.
Non-Standard GeometryConstruction Coordination
We work directly with architects, engineers, and general contractors from drawing set to frame-up, so nothing is lost in translation.
Full-Team FitDigital Modeling & CNC Fabrication
Every project is modeled in full 3D using Cadwork and cut on Hundegger CNC equipment — the same class of technology used to fabricate precision timber structures worldwide, applied here to custom homes and architectural builds. This is the layer underneath every service above.
3D Modeling · CNC CuttingRecent work
A working record of frames raised project to project. Select a project for the full scope.
Renderings shown are structural elevations generated from each project's model; on-site photography is added to a project's entry as it's completed.
An engineering approach to framing
NorthEdge frames high-end homes the way they're designed — as a coordinated structural model, not a stack of lumber and best guesses. Every member is planned, engineered, and cut before a crew ever sets foot on site.
That approach comes out of digital fabrication, not traditional framing. We model the full structure in 3D using Cadwork and cut it on Hundegger CNC equipment — the same class of technology used to fabricate precision timber structures worldwide. The result is a frame that goes up straighter, closer to plan, and with far less waste than a house framed by hand from a set of 2D drawings.
We work directly with architects and builders on the kind of homes where framing tolerance shows up in the finished product — long spans, compound rooflines, and structure that's meant to be seen, not just covered up. Because every frame is engineered and pre-cut before it leaves the shop, we take on the right project wherever it sits.
Send the drawing set.
Or just the address and a rough scope — we'll tell you what it takes to frame it right, and whether it's a fit for the shop.
